I did not see that issue when I tested it. I am currently out of the country. I will look into it again in about 2 weeks.

I am back in the country. I did some more testing with NT8. I still do not find any issues.

If you do not mind providing more information about your environment, I will attempt to reproduce it.

Which instrument are you using; the uniRenko parameters; the parameters you chose on the bar closes indicator.

Since there are multiple versions of uniRenko, please upload yours here so I can compare it with mine.

hello!, only marks the current price, does not mark the price where you should start next up and down as in the previous version, ninja 7

attached imag

Lets start with the basics:

Which instrument are you using; the uniRenko parameters; the parameters you chose on the bar closes indicator.

I use CL, ES, NQ ... The photo is ES with T5R10O5.. 5 ticks

I use unirenko with heiken , 5 ticks 3 ticks and 10 ticks,,

@justtrader,

Thank you for your efforts. The attached image shows YM 06-18 on NT8 running uniRenko with T14R14O6 settings. Per the chart, each bar's close is either 14 ticks higher or lower than the previous bar's close. That should imply that the two bar close readings from jprUnirenkoBarCloses are 28 ticks apart.

It appears in my case that the upper bar close value is correct (+14 from the previous close), but that the lower close value is low by an extra 14 ticks. It should be even with the red candle's close at 25039.



Regards.

dwt51

Thank you @dwt51 for pointing that out. The current version of BarCloses is not compatible with some versions of UniRenko as was pointed our earlier by @ramlamc6.

I am posting a new version, which takes into account some other UniRenko versions. Not sure which version you have. Do you mind disclosing which version you have and where you got it from?

justtrader 

Thank you @dwt51 for pointing that out. The current version of BarCloses is not compatible with some versions of UniRenko as was pointed our earlier by @ramlamc6. I am posting a new version, which takes into account some other UniRenko versions. Not sure which version you have. Do you mind disclosing which version you have and where you got it from?

Thank you for offering a new version.

My NT8 Unirenko bar type file is UniRenkoBarsType.cs, dated 2/18/2016. A look inside the file shows "Universal renko bar type. Ported by Sim22, 2015. [email protected]" . I believe I got this from the NinjaTrader support forum, but am not certain of that.

Regards.

dwt51

PS. I tried your _v4 version on the same NT8 YM 06-18 symbol T14R14O5 uniRenko bars and it appears to correctly call the high and low closes of the bars. Thanks !!

Thank you as well for helping figure out how your UniRenko worked so I could have the code sense it.

Is anyone having a issue of the jprUniRenkoBarCloses_V4 Bar Closes indicator of not saving? When ever I exit out of NT8 I have to reload the indicator. Any help would be appreciated.