Tradestation has a built in indicator for an inside bar (Below) However it does not print if either the high or low is equal to the prior bar. I did try typing in or = after the < . but it did not like my logic. Can anyone please tell where to put the equal bit

Thanks in advance.

if High < High[1] and Low > Low[1] then
begin
Plot1( Close, "Inside" ) ;
Alert ;
end
else
NoPlot( 1 ) ; { remove the marker }

Mickey Caine 

Tradestation has a built in indicator for an inside bar (Below) However it does not print if either the high or low is equal to the prior bar. I did try typing in or = after the < . but it did not like my logic. Can anyone please tell where to put the equal bit Thanks in advance. if High < High[1] and Low > Low[1] then begin Plot1( Close, "Inside" ) ; Alert ; end else NoPlot( 1 ) ; { remove the marker }

Proper EL is <= or >=

Is that what you're asking?

I did not know if that was what I was asking, but as it turned out, it was. Indicator now does exactly what I want.

Thank very much for your reply.