On zig-zag indicator, can the #'s show on top of fib lines?

See screenshot...notice how the zig zag tick count # of 26 is hard to see because it's buried under my fib retracement 50% line
https://screencast.com/t/YTU3ZDI0YT

Change the ZOrder = x value in #init, you'll have to play with it to get it where you want it. Positive and negative numbers are valid, if I recall.

Mike

I saw Ray demonstrate Z-order with a few indicators when he did the webinar but I don't remember where to go to see the z-order of the various indicators.

Can you remind me?

Yes, as I said above it is in #init. This means in Initialize of the indicator code.

Mike

I saw your note about #Init but I thought that you could change the z-order from a menu... I didn't think you had to go into the code to do it.

Do you recall what was Ray doing in the webinar to change z-order? He was changing z-order without going into the code.

Todd 

I saw your note about #Init but I thought that you could change the z-order from a menu... I didn't think you had to go into the code to do it. Do you recall what was Ray doing in the webinar to change z-order? He was changing z-order without going into the code.

It is something like hold ctrl then use mouse scroll wheel.

Mike

Todd 

I saw your note about #Init but I thought that you could change the z-order from a menu... I didn't think you had to go into the code to do it. Do you recall what was Ray doing in the webinar to change z-order? He was changing z-order without going into the code.

If you are referring to the order that the indicators display on the chart - click on the indicator you want. Hold down the shift key. Use the mouse scroll wheel to put it in the order you want. Hope this helps.

Mahlon