I'm getting the "none of the samples have sufficient data for optimization" error, and it doesn't seem to make sense why I would be getting it.

I'm only using one data source, my maxbarsback is 50 (signal references 14 and 9 bars back by default), my data goes back 1500 days, and my optimization is for 1000 days.

Any thoughts?

deltastrike 

I'm getting the "none of the samples have sufficient data for optimization" error, and it doesn't seem to make sense why I would be getting it. I'm only using one data source, my maxbarsback is 50 (signal references 14 and 9 bars back by default), my data goes back 1500 days, and my optimization is for 1000 days. Any thoughts?

it happens when you take daily data but in setting of the optimizer have data set in another time frame, like minutes

deltastrike 

I'm getting the "none of the samples have sufficient data for optimization" error, and it doesn't seem to make sense why I would be getting it. I'm only using one data source, my maxbarsback is 50 (signal references 14 and 9 bars back by default), my data goes back 1500 days, and my optimization is for 1000 days. Any thoughts?

Try adding a secondary series of the same or smaller resolution. This should prevent the data segmentation.

Hi,

I keep geting this eror too and do not Know what to do.
No one of Solutions above helps.

Whenever I get this error, I usually decrease the amount of days to optimize for, instead of 1000 days try 900 then 800 then 700 ect. see if this works