Good Morning,

I've been using a TEMA indicator where I added an HMA plot into my custom file and placed on a Tick Chart. I noticed that after awhile, the HMA plot (White/Black plot) starts "walking away" from it's original definition and is corrupted with each current candle. Not sure what was causing that so I placed a bare HMA plot over my indicator and utilized a dot plotstyle (Lime) so I could compare.

Possibly, my implementation of adding the secondary indicator to the TEMAv02 file is incorrect. I appreciate any help from the community!

p.s. I haven't noticed this problem on minute charts although I'm still analyzing/observing.

Many Ticks to You!
Kirk

I do not see any problems with your code.

For an answer please reproduce the problem

- and post a screenshot of the chart
- and another screenshot of the exact indicator settings that you have applied.

Also do not remove the indicator label and settings in the upper left corner of the chart.

Thanks Harry for looking into this. It took awhile for a chart to corrupt "before my eyes" so I could take a screenshot and save the indicator info you need to see. I didn't add the built-in HMA (shown on the 1st post) since I believe doing so would cause the corrupted HMA in the TEMAv03 file to revert to correct values. In any case, I'll try that after posting this reply.


TIA for your insight and response.
kz

As suspected, adding the built-in HMA caused the TEMAv03 HMAPlot to revert to "correct" values.