@Fat Tails

I hope all has been well for you, I need to ask a favor, can you please look at this and figure out why it wont plot. I am trying to load your anapivotsmonthly on a 8 renko chart they will not plot. Im using 90 days of data, any suggestions? Charts shown below

Many thx in Advance
R

Hope this helps,

Thx again
R

Data pic

Fat Tails has a version 39 now. Try downloading that for starters to see if that helps. My renko bars display, but I do not have rjay's though.

Rad4633 

@Fat Tails I hope all has been well for you, I need to ask a favor, can you please look at this and figure out why it wont plot. I am trying to load your anapivotsmonthly on a 8 renko chart they will not plot. Im using 90 days of data, any suggestions? Charts shown below Many thx in Advance R

You have used an exotic bar type, which I did not purchase. Therefore I cannot test your setup.

Could you please tell me whether the pivots plot

- on a default 8-Renko chart ?
- on a Better Renko chart ?


The problem may also be related to the indicator settings

- Auto: RTH pivots
- Session # for RTH: Second

Now your chart uses a template with a single session per day. But you apply the pivots indicator to the second RTH session, which does not exist on your chart.

These would be the correct settings:

ETH pivots: maintain your session template but switch from "Auto" to "ETH"
RTH pivots: you need to use a session template with 2 subsessions per day (night session and regular session) and may maintain the current indicator settings

Fat Tails 

You have used an exotic bar type, which I did not purchase. Therefore I cannot test your setup. Could you please tell me whether the pivots plot - on a default 8-Renko chart ? - on a Better Renko chart ? The problem may also be related to the indicator settings - Auto: RTH pivots - Session # for RTH: Second Now your chart uses a template with a single session per day. But you apply the pivots indicator to the second RTH session, which does not exist on your chart. These would be the correct settings: ETH pivots: maintain your session template but switch from "Auto" to "ETH" RTH pivots: you need to use a session template with 2 subsessions per day (night session and regular session) and may maintain the current indicator settings

Thank you for your reply, I tested and got it to work the setting that I had to change was calcFromIntradayBars. I started with a clean 240 chart and changed till i got it to work then switch to Renko. All is good now.

Thanks Again
R