Hi traders,

I am struggling with conversion of EasyLanguage code to NinjaScript especially with part where it should calculate indicator values. Here is the EL piece of code:

 

Code

VarL1 = AccumDist(Ticks); VarL2 = AccumDist(Ticks)[Shift1]; VarL3 = XAverage(VarL2, N1); VarL4 = WAverage(VarL3, N2)[Shift2]; VarL5 = XAverage(VarL4, N3); EntCondL = VarL1 < VarL5;

I tried to retype it into C# version

 

Code

if (ADL(Volume)[0] < EMA(WMA(EMA(ADL(Volume)[Shift1], N1), N2)[Shift2], N3)[0] ) EntCondL = true;

As a C# beginner I quite understand why it does not work in C#. EMA(ADL(Volume)[Shift1], N1) uses for calculation only a single value of ADL(Volume) at bar [Shift1]. But I don't understand then how EL can calculate XAverage (VarL3) using a single value of ADL instead of "array of values of ADL"

Any help on logic difference between EL and NS(C#) would be much appreciated

Thanks

tomas262 

Hi traders, I am struggling with conversion of EasyLanguage code to NinjaScript especially with part where it should calculate indicator values. Here is the EL piece of code:   Code VarL1 = AccumDist(Ticks); VarL2 = AccumDist(Ticks)[Shift1]; VarL3 = XAverage(VarL2, N1); VarL4 = WAverage(VarL3, N2)[Shift2]; VarL5 = XAverage(VarL4, N3); EntCondL = VarL1 < VarL5; ..... Thanks

maybe something like this? Disclaimer: I know nothing about EL.


...given VarL1 tp VarL5 are all dataseries.

VarL1.Set(OBV[0]);
VarL2.Set(OBV[1]); // OBV 1 back
VarL3.Set( EMA (VarL2, N1)[0]);
VarL4.Set( WMA(VarL3, N2)[2]); // 2 back??? not sure
VarL5.Set( EMA(VarL4, N3)[0]);

some sample

EasyLanguage OBV On Balance Volume Indicator Here is my custom version of the OBV (On Balance Volume) indicator. Plot 1, 2, 3 and 4 should be invisible and are just used for color reference. Let me know what you think. Below is the code, attached is the .pla for MultiCharts. ( ( // …