On the macd, i plot 2 lines.1 above zero line and 1 below.I set that at .0001 and -.0001.On a pb , i like for the histogram to penetrate these outside lines, to look for pullbacks.What is the best way to draw these, and then leave them forever? Ive been using rays, om nt8.Sometimes they disappear, and i need to redraw them.On 7 instruments, 14 charts, this can get irritating real quick!

bobarian 

On the macd, i plot 2 lines.1 above zero line and 1 below.I set that at .0001 and -.0001.On a pb , i like for the histogram to penetrate these outside lines, to look for pullbacks.What is the best way to draw these, and then leave them forever? Ive been using rays, om nt8.Sometimes they disappear, and i need to redraw them.On 7 instruments, 14 charts, this can get irritating real quick!

it's simple
1) make a copy of your MACD,
2) open indicator constant lines, copy some line of codes where red arrows or blue frame showed to your new MACD
3) compile new MACD
Note: at the first 2 arrows, specify the value you want instead of zero.

cory 

it's simple 1) make a copy of your MACD, 2) open indicator constant lines, copy some line of codes where red arrows or blue frame showed to your new MACD 3) compile new MACD Note: at the first 2 arrows, specify the value you want instead of zero.

Thank you Cory.I wish it was simple for me!I did this years ago, but there was no coding involved.