1. User can select from several MA types for the Moving Average plots, some of which are from Lizard Indicators made available by the GNU license. Credits to Lizard Indicators for both their indicators and the MA selection code.

2. When MA smoothing is selected the type can be an SMA, EMA, or the selected MA type. The smoothing period for each MA (fast, mid, and slow) can be set individually. A MA period of 0 eliminates the smoothing for that MA. Note: The Mid MA can be used as an intermediate period by specifying a value between the fast and slow periods. When the mid MA is requested with zero value for the period (default) will result in the mid period being calculated. If a period is specified and it is not between the fast and the slow the midpoint is calculated and used. No warning message is displayed.

3. The ability to apply volume filters (1-4) against the Net volume thereby limiting the Net volume histogram display a net bar only for the volume specified in the filter(s).

4. More control over how plots are displayed.

5. The divergence marker has been moved from the Total histogram to the Net histogram. This was done because the Total histogram can be turned off. The Net and/or Net filters must be active for the divergence marker to be displayed. If the Filter option is chosen without the Net plots being display the marker will only be display when there is a divergence on a filter value.|

6. The plot for the in-progress bar has its own color and can be user set. This plot is always displayed regardless of the display option selected.

7. This is not a change but a clarification as it also existed in the previous version. The position of the total line (above the line if a buy total and below the line if a sell total) is not based upon the last Close price but on the value (positive or negative) of the Net volume.

• 1. Buys and Sells are show above and below the zero line,
• 2. The Net Volume (Buys-Sells) is plotted accordingly,
• 3. Total volume is displayed using a separate color and is shown accordingly,
• 4. A divergence marker (Bar close is opposite the Net Volume) can be indicated (not enabled by default),
• 5. Tick Replay (TR) is supported and defaults to display a different color for the TR Net Volume bars,
• 6. The width of the Buy/Sell, total, and Net histogram bars can be set individually, and
• 7. Option to reverse the Histogram Buy/Sell and Net widths so that the Net bar displays on the inside of the Buys/Sell bar.

1. At times the Net volume is so small it can not be seen with the indicator region parameter set in Linear Mode. This can be rectified by setting it to Log mode as shown in the screenshot.
2. When changing the histogram bar sizes use odd numbers as the bars are painted from the midpoints.
3. For a divergence to be detected in addition to the Net number and bar direction being opposite it must pass a percentage check. If too many (too few) divergences are detected the percentage can be changed to reduce (increase) the number detected.
4. When using the Tick Replay with a large number of historical days (Days to Load) there may be a delay in the time it takes to initialize.
5. The indicator is installed in a folder named “Cheech”.

1. Fast and Slow EMA of Net Buy and Sells with optional midrange which when set the period is the midpoint of the Fast/Slow period settings.
2. User defined volume offset from Zero line will create a Zero Zone with optional region painting.
3. Reorganized Indicator Parameters.

1. If EMAs are too close together set the indicator panel properties Type Parameter to Logarithmic
2. NT will display the upper and lower boundary lines (the zero zone) under the following conditions; 1. tick replay is enabled, 2. real time data is available (data feed is connected and market is opened), or, 3. the Zero Zone region painting is enabled. When any of the aforementioned are satisfied the lines will appear.